Contact Us

If you still have questions or prefer to get help directly from an agent, please submit a request.
We’ll get back to you as soon as possible.

Please fill out the contact form below and we will reply as soon as possible.

  • Contact Us
  • Home
  • Products
  • Robotics
  • Collaborative Robots

How to set the IP address of the TM Robot Fieldbus port

Written by Arlo D'Cruz

Updated at July 31st, 2024

Contact Us

If you still have questions or prefer to get help directly from an agent, please submit a request.
We’ll get back to you as soon as possible.

Please fill out the contact form below and we will reply as soon as possible.

  • Products
    Automation Systems Control Components Motion & Drives Quality control & Inspection Robotics Safety Sensing Services Software Switching Components
  • Amplify e-Store
    e-Store public
  • Public CSC
+ More

Introduction

Currently, there is no way to set the IP address of the fieldbus port of the cobot for in the TM Flow 1.X software. The current intended method of setting the IP address of the robot is with CIP commands. This can be done with any CIP tool, but this guide shows how you might accomplish it with Network Configurator and Molex. 

Network Configurator

Your browser does not support HTML5 video.

Molex

Your browser does not support HTML5 video.
fieldbus setup configure ip ethernet port ethernet/ip eip

Was this article helpful?

Yes
No
Give feedback about this article

Related Articles

  • How to determine the route path for NX/NJ PLCs
  • MX2 Inverter Drive Control Input/Output Wiring Configurations
  • Manual/ Auto mode using the TM cobot

Definition by Author

0
0
Expand