Contact Us

If you still have questions or prefer to get help directly from an agent, please submit a request.
We’ll get back to you as soon as possible.

Please fill out the contact form below and we will reply as soon as possible.

  • Contact Us
  • Home
  • Products
  • Quality control & Inspection
  • Inspection systems

How to configure the FHV output as One-Shot

Written by Arlo D'Cruz

Updated at March 20th, 2025

Contact Us

If you still have questions or prefer to get help directly from an agent, please submit a request.
We’ll get back to you as soon as possible.

Please fill out the contact form below and we will reply as soon as possible.

  • Products
    Automation Systems Control Components Motion & Drives Quality control & Inspection Robotics Safety Sensing Services Software Switching Components
  • Amplify e-Store
    e-Store public
  • Public CSC
+ More

You may select from the following two methods for the timing of when the Overall Judgment (OR) signal turns OFF after measurement result confirmation.
This setting can be changed by setting One-shot OR signal in the communications specifications.

One-shot Output Disabled (Default)
The OR signal stays ON until the judgment changes.

One-shot Output
OR signal output stays ON for a certain amount of time, and then it is turned OFF again.
The time to maintain the OR signal output can be specified. (Setting range: 0.1 to 1000.0 [ms]).

The output type and period can be configured in the System Settings → Communication. Tick “One-shot OR signal” to enable one-shot behavior. The one-shot period is set in the “Output time[ms]” field. 

set-up single-trigger

Was this article helpful?

Yes
No
Give feedback about this article

Related Articles

  • CP1L-E Built-in Analog Input Setup

Definition by Author

0
0
Expand